Piaggio MP3 300 HPE - Owner's Manual > Dashboard

1. Ignition key-switch
2. Bag hook
3. Parking brake (where available)
4. Emergency turn indicator switch
5. Horn button
6. Turn signal switch
7. Rear brake lever
8. Light switch
9. Analogue instrument panel

12. Digital instrument panel
13. Warning light unit
14. Emergency cut-off switch RUN/OFF
15. Front brake lever
16. Throttle grip
17. Front suspension locking-unlocking switch (if available)
18. Starter button
19. MODE button

Analogue instrument panel

1. Immobilizer / anti-theft LED
2. Speedometer with twin scale (km/h and mph)
3. Fuel reserve warning light
4. Fuel gauge
5. Turn indicator warning light
6. High-beam warning light
7. Emergency turn indicator warning light
8. Warning light for parking brake engaged (where available)
9. Front suspension locking system warning light (where available)

12. Engine stop warning light
13. Front suspension locking system failure warning light (where available)
14. Digital display
15. Low oil pressure warning light
16. Engine control telltale light and injection system failure warning light
17. Coolant temperature gauge

Clock

Use the switch "MODE" to "ODO" mode Hold the switch "MODE" for more than 3 seconds, the hours will be displayed. Hours will increase each time the "MODE" button is pressed.

Once the hour is adjusted, hold the switch "MODE" more than 3 seconds to display the minutes. Minutes will increase each time the "MODE" button is pressed.

If no key is pressed for 3 seconds, the system will leave the clock adjustment mode.

WARNING

FOR SAFETY REASONS, CLOCK ADJUSTMENT IS POSSIBLE EXCLUSIVELY WITH VEHICLE SPEED EQUAL TO 0 Km/h.

Digital lcd display

1. Clock - date
2. "SERVICE" icon
3. Kilometre-mile indicator
4. State of battery charge icon
5. Odometer indicator, partial odometer I and II, state of battery charge and cyclically selectable ambient temperature with the "MODE" button
6. Ambient temperature indicator in degrees Celsius or Fahrenheit
7. Indicator "ODO", "ODO I" or "ODO II"
8. Low ambient temperature icon

Maintenance icons

At vehicle ignition, immediately after the ignition check, if there are less than 300 km to the next scheduled service, the corresponding icon flashes for 5 seconds. Once the scheduled service mileage is reached, the icon remains lit until the execution of the scheduled service.

*MODE* button

Pushing the MODE button "A" for less than a second displays the following sequence of functions:

• Total Odometer "ODO"
• Partial Odometer "ODO I"
• Partial Odometer "ODO II"
• State of battery charge
• Ambient temperature "º"

To reset the trip odometer, move "ODO I" or "ODO II" and press for more than three seconds the button MODE "A".

UNIT OF MEASUREMENT SETTING

When using the function measuring the voltage of the battery, holding down the MODE button for longer than 10 seconds will switch between reading in kilometres or miles for the odometer. For the first 5 seconds the display will not give any signal, for the next 5 seconds the message unit of measurement (Km or mi) currently in use will blink at a frequency of one flash per second. If the button is released before 10 seconds the measurement unit is not changed.

See also: