PIAGGIO Beverly 300ie - Service manual > Flywheel cover

Removing the hub cover

• Remove the clamps fastening the water pipes on the pump cover.
• Detach the pipes from the pump cover.

• Unscrew the ten screws fastening the flywheel, retrieving the indicated plate.
• Disconnect the electric connector from the minimum oil pressure switch.

• Remove the flywheel cover.

• Remove the gasket and be careful with the two alignment dowels.

Removing the stator

• Remove the two pickup screws and the screw holding the wiring support and the three stator clamping screws shown in the figure.
• Remove the stator and its wiring.

Refitting the stator

• Refit the stator and flywheel carrying out the removal procedure in reverse, tightening the retainers to the specified torque.

Locking torques (N*m)
Stator fixing screws 8 to 10 Pickup fixing screws 3 to 4

Refitting the flywheel cover

• Fit the gasket and be careful with the two alignment dowels.

• Position the spline clip on the crankshaft and orient the end as shown in the figure.

• Orient the water pump shaft with reference to the transmission gear seat as shown in the picture.

• Fit the flywheel cover complete with pump, ensuring that the alternator cable grommet is fitted correctly.
• Tighten the ten screws fastening the flywheel cover, ensuring that the indicated plate is positioned correctly.
• Reconnect the electric connector on the minimum oil pressure switch.

• Fit the water pipes onto the unions on the pump cover and tighten the clamps.

Locking torques (N*m)
Flywheel cover screw 11 ÷ 13

See also: