Suzuki Burgman 400 - Service manual > Repair Instructions
Fuel System Components
- Brake-lock cable
- Water drain hose
- Check valve
- Breather hose
- 5 mm (0.2 in)
Fuel Tank Heat Shield Construction
- Fuel tank
- Fuel tank heat shield
- Match the upper end of the fuel tank heat shield with the flange base.
- Match the fuel tank heat shield with the R-edge.
Fuel Cut Valve Removal and Installation
Removal
1) Remove the front box. Refer to "Front Box Removal and Installation".
2) Disconnect the hose (1) and remove the fuel cut valve (2).
Installation
Install the fuel cut valve in the reverse order of removal.
Pay attention the following points:
- Install the fuel cut valve with its protrusions "A" engaged with cutaway "B" on the gasket.
! CAUTION Replace the gasket with a new one.
- Install the fuel cut valve with its hose attaching section "C" facing the vehicle body right side.
- Tighten the fuel cut valve bolt to the specified torque.
Tightening torque
Fuel cut valve bolt (a): 3.5 N*m (0.35 kgf-m, 2.5 lb-ft)
See also:
Suzuki Burgman 400 - Service manual > Precautions
Precautions for Fuel System ! WARNING Keep away from fire or spark. During disassembling, use care to minimize spillage of gasoline. Spilled gasoline should be wiped off immediately. Work in a well-ventilated area.
Suzuki Burgman 400 - Service manual > Fuel Tank Removal and Installation
Removal 1) Remove the footboards. Refer to "Footboard Removal and Installation". 2) Remove the engine. Refer to "Engine Assembly Removal and Installation".