PIAGGIO Beverly 300ie - Service manual > Transmission cover

• Remove the air duct.
• With the specific tool lock the driven pulley, undo the indicated nut and collect the washer.

Specific tooling
  020423Y Driven pulley lock wrench

• Undo the eleven fixings screws to the engine and remove the transmission cover

N.B.

WHEN YOU ARE REMOVING THE TRANSMISSION COVER YOU MUST BE CAREFUL NOT TO DROP THE CLUTCH HOUSING.

Air duct

• Undo the three screws "1" and remove the crankcase cover "2".

• Undo the three screws "3" and remove the filter cover in the transmission housing "4".

• Take out the filtering element "5" from the cover.

Removing the driven pulley shaft bearing

• Remove the clip from the inside of the cover.
• Remove the bearing from the crankcase by means of:

Specific tooling
  020376Y Adaptor handle
  020375Y 28 x 30 mm adaptor
  020412Y 15-mm guide

Refitting the driven pulley shaft bearing

• Heat the crankcase from the inside.
• Insert the bearing in its seat.
• Refit the Seeger ring.

CAUTION

USE AN APPROPRIATE SUPPORT TO AVOID DAMAGING THE COVER SURFACE.

N.B.

ALWAYS REPLACE THE BEARING WITH A NEW ONE UPON REFITTING.

Specific tooling
  020376Y Adaptor handle
  020357Y 32x35-mm Adaptor
  020412Y 15-mm guide

Removing the driven pulley

• Remove the stationary driving half-pulley and the clutch housing.
• Remove the driven pulley together with the belt.

See also: