Vespa GTS 300 HPE - Owner's Manual > USB socket

On vehicles with this feature, a USB port A is situated inside the glove compartment, on the left hand side.

To use it, remove the protective cap. Refit the cap on the USB port to prevent damage caused by water or moisture.

CAUTION

THE SUPPLIED USB PORT IS SUITABLE FOR RECHARGING AND/OR POWERING MOST DEVICES CURRENTLY AVAILABLE ON THE MARKET.

The USB port is active once the key is turned to "ON".

CAUTION

PROLONGED USE OF THE PLUG SOCKET MAY RESULT IN PARTIAL DISCHARGE OF THE BATTERY

USB PORT

USB port

Opening the saddle to access the helmet compartment by remote control

The vehicle is equipped with a remote control to open the saddle and for the recognition of the vehicle itself.

• By pressing the buttons "1" or "2" of the remote control for about 3 seconds, the "Bike Finder" device will allow the opening at a distance of the saddle and the recognition of the vehicle with an optical signal by flashing the turn indicator. While holding one of the two buttons, the system will continue to repeat the operation described above until the button is released.
• By instead pressing the buttons "3" or "4" of the remote control, the "Bike Finder" device will be only activated for the recognition of the vehicle by emitting quick optical signals through the turn indicator.

Opening the saddle

With the key set to "OFF" or "ON", or with engine on, it is possible to electrically open the saddle by pressing button "C". If the electric opening does not work, use the emergency lever "A". When the key is set to "LOCK" the saddle cannot be opened.

Rear top box opening

Insert the key in the ignition switch and press down until the storage compartment opens. If the switch is set to "LOCK", turn the key to "OFF" or "ON" before pressing it down.

Bag clip

To use the retractable bag hook "B" mounted on the leg shield back plate, pull it slightly towards the back of the vehicle.

Identification

Identification registration numbers are made up of a prefix and a number, stamped on the frame and on the engine. The serial number must always be indicated when ordering spare parts. We recommend checking that the frame registration number stamped on the vehicle corresponds with that on the vehicle documentation.

CAUTION

PLEASE REMIND THAT ALTERING IDENTIFICATION REGISTRATION NUMBERS CAN LEAD TO SERIOUS PENAL SANCTIONS (IMPOUNDING OF THE VEHICLE, ETC.).

Frame number

The chassis number "A" is stamped near the fuel tank.

To read it, proceed as follows:

• lift the saddle;

• lift the helmet compartment by removing it.

Engine number

The engine number "B" is stamped near the rear left shock absorber lower support.

See also: