PIAGGIO Beverly 300ie - Service manual > Exhaust bracket
Removal
- Remove the silencer;
- Disconnect the connector from the speed sensor;
- Unscrew the lower bolt fastening the right hand shock absorber, remove the shock absorber from its seat and retrieve the shim;
- Unscrew the screw indicated in the figure and release the rear brake hose from the silencer mounting bracket;
- Unscrew the two bolts fastening the rear brake calliper to the silencer mounting bracket;
- Unscrew the two screws fastening the rear mudguard indicated in the figure;
- Working from the left hand side of the vehicle, unscrew the two screws indicated and remove the rear mudguard;
- Remove the safety split pin, aligning with the recess on the bracket. Remove the nut cap;
- Undo the nut fastening the rear wheel;
- Unscrew the two screws fastening the silencer mounting bracket to the engine, as indicated in the figure, and remove the bracket.
Overhaul
- Remove the circlip shown in the picture
- Support the silencer support bracket sufficiently
- Using the special punch, remove the bearing from its seat as shown in the picture
Specific tooling
020376Y Adaptor handle
020456Y Ø 24-mm adaptor
- Heat the bearing seat using the heat gun
- Using the special punch, install a new bearing in the seat as shown in the picture
Specific tooling
020376Y Adaptor handle
020151Y Air heater
Refitting
To refit, carry out the removal operations in reverse order, observing the prescribed tightening torques.
N.B.
THE SILENCER SUPPORT ARM MUST BE TIGHTENED AFTER TIGHTENING THE WHEEL.
Locking torques (N*m)
Rear wheel axle nut 104 ÷ 126 Silencer supporting arm to engine screws
(*) 20 to 25 Right shock absorber lower retainer 40 ÷ 45
Centre-stand
- Remove the two return springs from the centre stand.
- Undo the nut shown in the figure.
- Remove the pin from the right side.
- Remove the centre stand.
- On refitting tighten the nut to the specified torque.
Locking torques (N*m)
Centre stand bolt 40 to 45
Side stand
Removal of the side stand
- Unhook the springs;
- Loosen the nut;
- Pull out the screw;
Fitting
Carry out the previous operations but in reverse order.
Locking torques (N*m)
Side stand fixing bolt 40 to 45
See also:
PIAGGIO Beverly 300ie - Service manual > Recommended products
AGIP GREASE PV2 Ivory smooth-textured, slightly-stringy anhydrous calcium-base grease. TL 9150 066, NATO G 460 symbol Refitting In order to fit the swinging arm properly, follow these steps: Position the silent block support bracket with part "3 " pre-fitted and screw in but do not tighten part "1". Position the swinging arm, inserting part " 2". Tighten part "3" to the prescribed torque. Screw and tighten part "4" to the prescribed torque. Screw and tighten part "5" to the prescribed torque. Tighten part "1" to the prescribed torque. Insert the swinging arm - engine pin and tighten to the prescribed torque.
