PIAGGIO Beverly 300ie - Service manual > Braking system
- Interventions rules
- Rear/Front brake calliper
- Rear/Front brake disc
- Rear/Front brake pads
- Fill
- Front/Rear brake pump
See also:
PIAGGIO Beverly 300ie - Service manual > Exhaust bracket
Removal Remove the silencer; Disconnect the connector from the speed sensor; Unscrew the lower bolt fastening the right hand shock absorber, remove the shock absorber from its seat and retrieve the shim; Unscrew the screw indicated in the figure and release the rear brake hose from the silencer mounting bracket; Unscrew the two bolts fastening the rear brake calliper to the silencer mounting bracket; Unscrew the two screws fastening the rear mudguard indicated in the figure; Working from the left hand side of the vehicle, unscrew the two screws indicated and remove the rear mudguard; Remove the safety split pin, aligning with the recess on the bracket. Remove the nut cap; Undo the nut fastening the rear wheel; Unscrew the two screws fastening the silencer mounting bracket to the engine, as indicated in the figure, and remove the bracket.
PIAGGIO Beverly 300ie - Service manual > Interventions rules
WARNING BRAKING SYSTEM FLUID IS CORROSIVE: ALWAYS WEAR PROTECTIVE GLOVES. IN THE EVENT OF ACCIDENTAL CONTACT WITH YOUR EYES, RINSE THE CONTACT AREA WELL WITH ABUNDANT WATER.
