PIAGGIO Beverly 300ie - Service manual > Rear/Front brake pads
Front brake pads
Removal
Proceed as follows:
- Remove the front brake calliper.
- Loosen the two pins shown in the figure that lock the two pads.
- Remove the pads, being careful with the pad spring clamp.
- Check the thickness of the friction material of the pads.
- Replace the pads if the thickness is below the minimum value.
- The replacement must be made with greater residual thickness if the pad has not worn evenly. A 0.5 mm thickness difference in the residual friction material is permitted.
Characteristic
Minimum value
1.5 mm
Refitting
To fit, proceed as follows:
- Insert the two pads in the callipers.
- Screw the two pad lock pins to the correct torque, and apply the recommended product.
- Fit the calliper on its support, tightening the two screws to the prescribed torque.
N.B.
IF IT IS NOT POSSIBLE TO CORRECTLY POSITION THE CALLIPER ON THE DISC DURING FITTING, GENTLY EXPAND THE PADS.
Recommended products
Loctite 243 Medium-strength threadlock
Medium Loctite 243 threadlock
Locking torques (N*m)
Pad fastening pin 19.6 to 24.5
Rear brake pads
Removal
- Remove the rear brake calliper
- Loosen the two pins shown in the figure that lock the two pads; be careful with the pad spring clamp.
- Remove the brake pads and check there are no faults or warping. Replace it if such anomalies are present.
- Check the thickness of the friction material is more than 1.5 mm. If it is not, replace it
- The replacement must be made with greater residual thickness if the brake pad has not worn evenly. A 0.5 mm thickness difference in the residual friction material is permitted.
Refitting
To fit, proceed as follows:
- Insert the two pads in the callipers.
- Screw the two pad lock pins to the correct torque, and apply the recommended product.
- Fit the calliper on its support, tightening the two screws to the prescribed torque.
N.B.
IF IT IS NOT POSSIBLE TO CORRECTLY POSITION THE CALLIPER ON THE DISC DURING FITTING, GENTLY EXPAND THE PADS.
Recommended products
Loctite 243 Medium-strength threadlock
Medium Loctite 243 threadlock
Locking torques (N*m)
Screw tightening calliper to support 24 to 27 Pad fastening pin 19.6 to
24.5
See also:
PIAGGIO Beverly 300ie - Service manual > Rear/Front brake disc
Rear brake disc These vehicles may feature a rear wheel with integrated hub or with a hub independent from the wheel. Removal REAR WHEEL WITH INTEGRATED HUB Remove the rear wheel. Act on the disc five fixing screws shown in the picture.
PIAGGIO Beverly 300ie - Service manual > Fill
Rear - combined Remove the rubber cap from the bleed screw. Insert a rubber pipe in the bleed screw to permit the brake fluid to be recovered. With the brake lever, load the system and bring it up to the required pressure. Keeping the brake lever pulled, loosen the bleed screw to purge the air in the system. Then tighten the bleed screw Repeat the operation until only brake fluid comes out of the rubber pipe. Remove the fluid recovery pipe and refit the rubber cap over the bleed screw. Top up the brake fluid to the right level in the reservoir.
