PIAGGIO Beverly 300ie - Service manual > Rear/Front brake disc
Rear brake disc
These vehicles may feature a rear wheel with integrated hub or with a hub independent from the wheel.
Removal
REAR WHEEL WITH INTEGRATED HUB
- Remove the rear wheel.
- Act on the disc five fixing screws shown in the picture.
Refitting
REAR WHEEL WITH INTEGRATED HUB
For fitting, position the disc correctly using the arrow stamped on it as reference.
N.B.
THE ARROW STAMPED ON THE DISC INDICATING THE RUNNING DIRECTION MUST BE FITTED TOWARDS THE OUTSIDE OF THE VEHICLE.
- Tighten the screws to the prescribed torque and apply the recommended product.
Recommended products
Loctite 243 Medium-strength threadlock
Medium Loctite 243 threadlock
Locking torques (N*m)
Brake disc screws 8 ÷ 10
Disc Inspection
Checking the disc is important; it must be perfectly clean, with no sign of rust, oil or grease or any other dirt, and must show no signs of deep scoring.
Characteristic
New rear disc thickness
4.0 mm
Disc thickness at wear limit (rear)
3.5 mm
- Using the specific tool, check that the axial runout of the brake surface is within the prescribed limits.
- If this is not the case, replace the disc and repeat the test.
WHEN INSTALLING, THOROUGHLY CLEAN THE DISC AND ITS SEAT ON THE HUB.
Characteristic
Max. axial run-out
0.1 mm
Front brake disc
Removal
Proceed as follows:
- Remove the front wheel.
- Loosen the five disc fixing screws.
- Thoroughly clean the seats on the front wheel hub and on the disc.
Refitting
For fitting, position the disc correctly using the arrow stamped on it as reference.
- Do up the screws to the prescribed torque and apply the recommended product
N.B.
THE ARROW STAMPED ON THE DISC INDICATING THE RUNNING DIRECTION MUST BE FITTED TOWARDS THE OUTSIDE OF THE VEHICLE.
Recommended products
Loctite 243 Medium-strength threadlock
Medium Loctite 243 threadlock
Locking torques (N*m)
Brake disc screws 8 ÷ 10
Disc Inspection
Checking the disc is important; it must be perfectly clean, with no sign of rust, oil or grease or any other dirt, and must show no signs of deep scoring.
Characteristic
Thickness of a new front disc
4.0 mm
Disc thickness at wear limit (front)
3.5 mm
- Remove the wheel and check using the appropriate tools that the axial run-out of the brake surface is within the prescribed limits.
- If this is not the case, replace the disc and repeat the test.
WHEN INSTALLING, THOROUGHLY CLEAN THE DISC AND ITS SEAT ON THE HUB.
Characteristic
Max. axial run-out
0.1 mm
See also:
PIAGGIO Beverly 300ie - Service manual > Rear/Front brake calliper
Rear brake calliper Removal Remove the rear wheel. Remove the two rear brake calliper devices fastening them to the support as shown in the picture.
PIAGGIO Beverly 300ie - Service manual > Rear/Front brake pads
Front brake pads Removal Proceed as follows: Remove the front brake calliper. Loosen the two pins shown in the figure that lock the two pads. Remove the pads, being careful with the pad spring clamp. Check the thickness of the friction material of the pads. Replace the pads if the thickness is below the minimum value. The replacement must be made with greater residual thickness if the pad has not worn evenly. A 0.5 mm thickness difference in the residual friction material is permitted.
