Suzuki Burgman 400 - Service manual > Rear Reflector/ Rear Combination Light

Rear Reflector / Rear Combination Light / License Light Components

1. Rear combination light
2. Brake light/taillight bulb
3. Rear turn signal light bulb
4. License light lens
5. License light bulb
6. Socket

Rear Reflector / Rear Combination Light / License Light Removal and Installation

Rear Reflector

Removal

1) Remove the mat of the helmet box.

2) Remove the reflector nuts (1) and reflector (2).

Installation

Install the rear reflector in the reverse order of removal.

Rear Combination Light

Removal

1) Remove the left and right frame covers. Refer to "Frame Cover Removal and Installation".

2) Remove the rear combination light.

NOTE Care should be used not to cause scratch or damage to the frame cover and rear combination light.

Installation

Install the rear combination light in the reverse order of removal.

License Light

Removal

1) Remove the lower frame cover. Refer to "Lower Frame Cover Removal and Installation".

2) Remove the license plate light cover (1).

3) Remove the license plate light (2) from the license plate light cover (3).

Installation

Install the license plate light in the reverse order of removal.

Rear Combination Light Bulb / License Light Bulb Replacement

Refer to "Rear Reflector / Rear Combination Light / License Light Components".

! CAUTION

• A fouled glass can cause damage to the bulb when lit. If the bulb is contacted with bare a hand, wipe clean with a cloth damped with alcohol or detergent.
• Do not use the bulb of a wattage other than specification.

NOTE To replace the brake light/taillight bulb or rear turn signal light bulb, the same procedures is applicable to both the right and left lights.

Brake Light / Taillight Bulb

Replace the brake light/taillight bulb in the following procedures:

1) Remove the lower frame cover. Refer to "Lower Frame Cover Removal and Installation".

2) Remove the socket (1) by turning it counter clockwise.

3) Replace the brake light/taillight bulb.

4) After finishing the brake light and taillight bulb replacement, reinstall the removed parts.

Rear Turn Signal Light Bulb

Replace the rear turn signal light bulb in the following procedures:

1) Remove the center frame cover. Refer to "Center Frame Cover Removal and Installation ".

2) Remove the socket (1) by turning it counter clockwise.

3) Replace the rear turn signal light bulb.

4) After finishing the rear turn signal light bulb replacement, reinstall the removed parts.

License Light Bulb

Replace the license light bulb in the following procedures:

1) Remove the lens by turning it counter clockwise.

2) Replace the license light bulb.

3) After finishing the license light bulb replacement, reinstall the removed parts.

See also: